Thursday June 23, 2005
The day began with the clearing of some residual brush. Lines were laid for T-43A and a dirt dump was established down the path to the south. A relative datum point was established by nailing a nail into the largish tree directly to the north of the trench.
A preliminary sketch of the trench is located on the following page.
Opening elevations for Locus 1 of T-43A were as follows:
- NW: 100 cm b.d. (A)* 24.57 m absolute elevation
- SW: 68 cm b.d. (B) 23.21 m absolute elevation
- NE: 157.5 cm b.d.(A) 23.995 m absolute elevation
- SE: 110.5 cm b.d. (B) 22.785 m absolute elevation
- Center: 40 cm b.d. (B) 23.49 m absolute elevation
* The northwestern corner's elevation will remain stable during excavation due to the presence of a large stump in that corner that will not be removed during the course of excavation.
* b.d. = below the relative datum point
Because of the extreme slope of the hill, two separate relative datum points had to be established so that all areas of the trench could have elevations taken. One, that previously mentioned and referred to as "A", was established in a tree directly northe of the trench. It will be used for the northern half of the trench. The second point, referred to as "B" and located just outside of T-43B, will be used for the sourthern half of the trench. Point "B"is the same relative point used by T-43B (see JMH I pg. 9).
A ca. 5 cm pick pass of the northern half of the trench was taken. During sifting a piece of pottery with yellowish glaze, presumably medieval, was found.
We continued to pick and sort the trench. We began defining the rocks visible in the northern poriton of the trench. THese rocks are approximately in line and are perhaps evidence of the existence of the retaining wall in this area. WHile defining the rocks a large chunk of charcoal was discovered.
Material Yield for June 23:
- 1 1/8 latte box of terracotta
- 2 special finds
- 3 pottery sherds
Pottery Summary for June 23:
- Locus 1
- 3 impasto (1 base, 2 body)
|Property or Relation||Value(s)|
[Standard: Dublin Core Terms]
Open Context editors work with data contributors to annotate datasets to shared vocabularies, ontologies, and other standards using 'Linked Open Data' (LOD) methods.
The annotations presented above approximate some of the meaning in this contributed data record to concepts defined in shared standards. These annotations are provided to help make datasets easier to understand and use with other datasets.
To the extent to which copyright applies, this content
carries the above license. Follow the link to understand specific permissions
Required Attribution: Citation and reference of URIs (hyperlinks)